How to replace Carbon Brushes on NSK Viva-Mate 3 / Volvere i7 / Vmax motor
Replacing Carbon Brushes NSK Viva-Mate 3 / Volvere i7 / Vmax motor
Read the official user guide on how to replace the original carbon brushes for NSK Motor Viva-Mate 3 / Volvere i7 / Vmax – Original part Number E023011S
0M-E0012
- Loosen the cord nut at the motor back-end. (Fig. 1)
- Remove two screws that secure the carbon brushes with a flat-blade screw driver. (Fig. 2)
- Screw the pull-out screw, which is provided in a replacement carbon brush case, a few threads into the hole from which the short screw was removed in Step. (2). Remove the carbon brush by pulling out this screw. (Fig. 3)
Mount new carbon brushes in place, and secure them with the short screws used on the removed brushes.- Insert the cord nut pins into the holes on the motor, aligning the marked pin to the marked hole (red marked or molded + marking) and non-marked pin to non-marked hole. (Fig. 4)
* If the marked one is connected to the non-marked one, the motor runs in the reverse direction.
molded+markings
NAKANISHI INC.
HEAD OFFICE & FACTORY 700 Shimohinata, Kanuma-shi Tochigi-ken 322-8666 Japan Telephone: 0289-64-3380 Fax: 0289-62-5636
TOKYO OFFICE 9F TIXTOWER UENO 4-8-1 Higashiueno Taito-ku Tokyo 110-0015. Japan Telephone: 03-5828-4180 Fax: 03-5828-0064
Ihttp://www.nsk-inc.com e-mail: cs@nsk-nakanishi.com
